Ara
Toplam kayıt 69, listelenen: 41-50
Direct and indirect signal detection of 122 keV photons with a novel detector combining a pnCCD and a CsI(T1) scintillator
(Elsevier, 2016)
By combining a low noise fully depleted pnCCD detector with a CsI(TI) scintillator, an energy-dispersive area detector can be realized with a high quantum efficiency (QE) in the range from below 1 keV to above 100 keV. In ...
Calibration-free extraction of constitutive parameters of magnetically coupled anisotropic metamaterials using waveguide measurements
(Amer Inst Physics, 2017)
A calibration-free method for extraction of electromagnetic properties of magnetically coupled anisotropic biaxial metamaterial (MM) slabs from waveguide measurements is proposed. It relies on three measurement steps (thru, ...
Comparison of deep drawability of AA5754-H22 and AA6061-T6 aluminum alloys for automotive applications
(Carl Hanser Verlag, 2017)
Being one of the most commonly applied sheet metal forming processes in automotive industry, deep drawing technologies are challenged by the concerns of global warming for higher fuel economy requirements in the recent ...
A new spectroscopic imager for X-rays from 0.5 keV to 150 keV combining a pnCCD and a columnar CsI(Tl) scintillator
(Iop Publishing Ltd, 2017)
By combining a low noise fully depleted pnCCD detector with a columnar CsI(Tl) scintillator an energy dispersive spatial resolving detector can be realized with a high quantum efficiency in the range from below 0.5 keV to ...
Mechanical characterization of B4C reinforced aluminum matrix composites produced by squeeze casting
(Cambridge Univ Press, 2017)
Boron carbide (B4C) ceramic particles were used as reinforcement material to produce aluminum (Al) matrix composites by squeeze casting method. Four different B4C contents as 0, 3, 5, and 10 wt%, and three different squeeze ...
Novel metaheuristic-based tuning of PID controllers for seismic structures and verification of robustness
(Elsevier Ltd, 2021)
In the present study, an active structural control using metaheuristic tuned Proportional-Integral-Derivative (PID) type controllers is presented. The aim of the study is to propose a feasible active control application ...
An experimental study on the heat transfer and wettability characteristics of micro-structured surfaces during water vapor condensation under different pressure conditions
(Elsevier Ltd, 2021)
In this study, condensation characteristics of water vapor on micro-structured surfaces at different pressures and subcooling temperature has been investigated experimentally. This work represents a basic study in order ...
An experimental and analytical study on the influence of superhydrophobic micro-textured surfaces on liquid wetting phenomena
(Elsevier Science Bv, 2018)
Controlling dust, particle, gas or liquid attachment or motion over the surfaces is attracting many researchers to reduce losses or reach mission-specific goals. Therefore, researchers have been developing novel surfaces ...
Core-shell PVA/gelatin nanofibrous scaffolds using co-solvent, aqueous electrospinning: toward a green approach
(Wiley, 2018)
Electrospinning (ES) of gelatin often requires cytotoxic organic solvents or acidic environments, which deteriorate cell recognition sites. In this study, aqueous, non-toxic, co-solvent ES was performed to obtain core-shell ...
Preparation and characterization of porous hydroxyapatite pellets: effects of calcination and sintering on the porous structure and mechanical properties
(Sage Publications Ltd, 2016)
In this study, porous hydroxyapatite structures were produced by using urea particles of 600-850 mu m size. Samples with two different urea composition (25 and 50 wt%) were prepared along with samples without any urea ...