Ara
Toplam kayıt 160, listelenen: 61-70
Comprehensive group pile settlement formula based on 3D finite element analyses
(Japanese Geotechnical Soc, 2018)
In the past, formulas for the settlement of group piles considered only a few input parameters and offered only a limited approximation of the actual settlement. Nowadays, however, thanks to the fast-growing performance ...
Spatio-temporal accident analysis for accident prevention in relation to behavioral factors in driving: the case of South Anatolian Motorway
(Elsevier Sci Ltd, 2015)
Analyzing the pattern of traffic accidents on road segments can highlight the hazardous locations where the accidents occur frequently and help to determine problematic parts of the roads. The objective of this paper is ...
Direct and indirect signal detection of 122 keV photons with a novel detector combining a pnCCD and a CsI(T1) scintillator
(Elsevier, 2016)
By combining a low noise fully depleted pnCCD detector with a CsI(TI) scintillator, an energy-dispersive area detector can be realized with a high quantum efficiency (QE) in the range from below 1 keV to above 100 keV. In ...
Calibration-free extraction of constitutive parameters of magnetically coupled anisotropic metamaterials using waveguide measurements
(Amer Inst Physics, 2017)
A calibration-free method for extraction of electromagnetic properties of magnetically coupled anisotropic biaxial metamaterial (MM) slabs from waveguide measurements is proposed. It relies on three measurement steps (thru, ...
Single-shot full strain tensor determination with microbeam X-ray Laue diffraction and a two-imensional energy-dispersive detector
(Int Union Crystallography, 2017)
The full strain and stress tensor determination in a triaxially stressed single crystal using X-ray diffraction requires a series of lattice spacing measurements at different crystal orientations. This can be achieved using ...
Comparison of deep drawability of AA5754-H22 and AA6061-T6 aluminum alloys for automotive applications
(Carl Hanser Verlag, 2017)
Being one of the most commonly applied sheet metal forming processes in automotive industry, deep drawing technologies are challenged by the concerns of global warming for higher fuel economy requirements in the recent ...
SAR moving object imaging using sparsity imposing priors
(Springer, 2017)
Synthetic aperture radar (SAR) returns from a scene with motion can be viewed as data from a stationary scene, but with phase errors due to motion. Based on this perspective, we formulate the problem of SAR imaging of ...
A new spectroscopic imager for X-rays from 0.5 keV to 150 keV combining a pnCCD and a columnar CsI(Tl) scintillator
(Iop Publishing Ltd, 2017)
By combining a low noise fully depleted pnCCD detector with a columnar CsI(Tl) scintillator an energy dispersive spatial resolving detector can be realized with a high quantum efficiency in the range from below 0.5 keV to ...
Mechanical characterization of B4C reinforced aluminum matrix composites produced by squeeze casting
(Cambridge Univ Press, 2017)
Boron carbide (B4C) ceramic particles were used as reinforcement material to produce aluminum (Al) matrix composites by squeeze casting method. Four different B4C contents as 0, 3, 5, and 10 wt%, and three different squeeze ...
Novel metaheuristic-based tuning of PID controllers for seismic structures and verification of robustness
(Elsevier Ltd, 2021)
In the present study, an active structural control using metaheuristic tuned Proportional-Integral-Derivative (PID) type controllers is presented. The aim of the study is to propose a feasible active control application ...