Basit öğe kaydını göster

dc.contributor.authorTozkoparan, Ömer Anıl
dc.contributor.authorYenerer, Hakan
dc.contributor.authorŞen, Osman Taha
dc.contributor.authorGüneş, Sunay
dc.contributor.authorÖzmen, Başaran
dc.contributor.authorHaack, Matthias
dc.contributor.authorWalther, Frank
dc.contributor.authorİpekoğlu, Mehmet
dc.date.accessioned2021-01-08T21:51:32Z
dc.date.available2021-01-08T21:51:32Z
dc.date.issued2017
dc.identifier.urihttps://hdl.handle.net/20.500.12846/345
dc.descriptionMeetings and Exhibitions Hong Kong (MEHK)en_US
dc.description46th International Congress and Exposition on Noise Control Engineering: Taming Noise and Moving Quiet, INTER-NOISE 2017, 27 August 2017 through 30 August 2017, , 131923en_US
dc.description.abstractIn this paper, the high frequency noise problem brake squeal observed in automotive disc brake systems is experimentally and computationally investigated. Firstly, modal testing on the components of the brake system (brake disc, brake pad, carrier, caliper) is performed and the corresponding natural frequencies and mode shapes are obtained. Secondly, computational models of the given components are built and normal mode analyses are executed. A good match between the experimental and computational results is obtained in terms of both frequencies and mode shapes. Thirdly, a computational model of the brake corner assembly is built with the validated component models. Squeal analysis is then performed for different speed and brake pressure levels by using complex eigenvalue analysis. Based on the results, speed and brake pressure values that have high squeal propensity are identified. Finally, a controlled laboratory experiment is designed and built for the squeal investigation. In the setup, only a single brake corner assembly excluding the suspension system is used. During the experiments, acceleration and sound pressure data are recorded. Experiments at different speed and hydraulic brake pressure levels are performed, and several squeals are successfully measured at the same levels as calculated with the computational model. In conclusion, a finite element method for brake squeal is developed and experimentally validated. © 2017 Institute of Noise Control Engineering. All rights reserved.en_US
dc.language.isoengen_US
dc.publisherInstitute of Noise Control Engineeringen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectBrake squealen_US
dc.subjectFinite element analysisen_US
dc.subjectHigh frequency noiseen_US
dc.titleExperimental and computational investigation of disc brake squealen_US
dc.typeconferenceObjecten_US
dc.relation.journalINTER-NOISE 2017 - 46th International Congress and Exposition on Noise Control Engineering: Taming Noise and Moving Quieten_US
dc.identifier.volume2017-Januaryen_US
dc.relation.publicationcategoryKonferans Öğesi - Uluslararası - Kurum Öğretim Elemanıen_US
dc.contributor.departmentTAÜ, Mühendislik Fakültesi, Makine Mühendisliği Bölümüen_US
dc.contributor.institutionauthorİpekoğlu, Mehmet
dc.identifier.scopusqualityN/Aen_US


Bu öğenin dosyaları:

DosyalarBoyutBiçimGöster

Bu öğe ile ilişkili dosya yok.

Bu öğe aşağıdaki koleksiyon(lar)da görünmektedir.

Basit öğe kaydını göster